add wishlist add wishlist show wishlist add compare add compare show compare preloader

AtomRC Official

Customer Reviews

Based on 5 reviews
60%
(3)
20%
(1)
20%
(1)
0%
(0)
0%
(0)
P
Paul Romprey
??????????

It’s been weeks now and still don’t know how to hook it up it only show how to use sbus …….not sure what the capacitor is for. And how and why to use it? There only a wire diagram but only show Sbus hook up how do I hook up spektrum rx ?

s
salvatore Patti
Great Parts

I had someone elses FC in a plane and it went bad. I really like Atomrc planes and other parts, so I had to order a new FC and it's an Atomrc F405 Nav.

N
Niko Kumar
Works great - assembly istructions highly needed

The ATOMRC FC is great. The only issue I have had, was to figure out the assembly of the pins, as there are no clear instructions for "low qualified" soldering DIY hobbysts. My recomendation would be : work on that a bit.
The VTX, GPS and other modules are attached via soldered bus - super easy. Works great, accurate and reliable.
I can only say that if Apollo 11 would have had such flight computer on board, back in 1969 - we would have already had a moon base up there!

G
Gijsbert Jansen
FC by atomRC

This is a one-stop solution. It works really fine and is a valuable piece of core-technology in the innovative repertoire of atomRC. The only problem I encounter with atomRC (and therefore 4 instead of 5 stars) is [****]. This guy Daniel does not communicate at all. I start wondering if he actually exists (!). For the rest: keep up the good work!!

J
Jess Barkley
Excellent Flight Controller for most fixed wing aircraft inav. (Setup and Assembly can be Tedious)

This flight controller offers all the options one could want or need for a fixed wing with 3-6s Lipo or equivalent power input, a micro sd slot, pads for either single or multi, up to (2) esc configuration options for single or dual engine planes, it provides receiver support for TBS Nano, FrSky, as well as some spectrum rx via sBus, as well as, a dedicated port for a DJI air unit, digital or analog vtx and cameras, it provides a dedicated port for up to 6 pin GPS with a 4 pin pigtail included. All dedicated ports include pigtail connectors. There are loads of uarts and a handful of different voltage power supplies on board. There is a small breakout board with a usb-c port for programing and a small buzzer along with a system power switch all connected to this piece. There are probably more options available that I'm not thinking of at the moment. The FC is designed for inav and ardu firmwares if I'm not mistaken. Assembly is somewhat tedious due to the tiny-ness of the getup imo, which is typical, but, the hardware looks to be high quality, solid and very well designed.

Light
Dark